View Table of Contents
Gusmer Enterprises Cellu-Stack ® Filters
Gusmer Enterprises’ Cellu-Stacks are a convenient way to utilize depth filtration media in an enclosed system. Offered in many Gusmer media grades, these stack filters can be used for coarse, fine and presterile filtration in numerous filtration applications. • Full range of filter media grades with high adsorptive and retention properties • Clean and safe filtration method when dealing with elevated pressures, temperatures, etc. • Convenient operation with short setup or changeover times • Small process footprint • Designed to conform with GMP • Highly economical with minimal maintenance and low operating costs • Protection of filtrate against spoilage in an enclosed depth filtration system
Stack Specifications
176 o F (80 o C)
Max. Operating Temp. Steam in Place - 3 cycles Max. Differential Pressure Recommended Rinse Volume
253 o F (123 o C)
30 psid (2.1 bar)
Contact your Gusmer representative for the optimal grade selection for your filtration application.
2.5 gal/ft 2 (100 L/m 2 )
Gusmer Enterprises Select Filter Housings
Cellu-Stack Housing & Cartridge Demonstration Gusmer Enterprises’ Select filter housings are designed as a cost-effective system for high capacity liquid filtration applications. The Select housing line accommodates 12” diameter Cellu-Stack® filter cartridges with the effective filtration surface area of 17.7 ft 2 . All housings are available in 1, 2, 3, or 4-cartridge versions, which can be modified with the use of Cellu-Stack adapters to accept fewer cartridges for partial batch runs or other applications requiring fewer cartridges. Cellu-Stack Application Notes: • Place a quick acting check valve at the housing outlet to avoid integrity breaches that can be caused by backpressure • Double check that all cartridge gaskets are in place and in good condition to ensure optimal sealing • If filter life is not fully exhausted by a single filtration, DO NOT remove used filters from the housing for storage between uses. Instead, used filters can be stored IN the housing for short term periods by following these steps: - Shut Down: After completion of the filtration cycle, sanitize the filters with the same method used to prepare the filters (i.e. steam or hot water flush) - S torage: Drain the housing, apply 2 psi gas
pressure (i.e. CO 2 , nitrogen) while the housing is still warm (to avoid a vacuum upon cooling) and close all ports - R estart: When restarting for another filtration cycle, repeat the sanitization procedure just as you would for normal filter preparation
34 2024 - 2025 Gusmer Enterprises, Inc. Wine Products Catalog
Powered by FlippingBook